Regency U41-LP3 用户手册

Regency U41-3 ULTIMATE Gas Fireplace Insert

It is possible that you will hear some sounds
from your gas appliance. This is perfectly
normal due to the fact that there are various
gauges and types of steel used within your
appliance. Listed below are some examples.
All are normal operating sounds and should
not be considered as defects in your appliance.

Blower:
Regency gas appliances use high tech blow-
ers to push heated air farther into the room. It
is not unusual for the fan to make a "whirring"
sound when ON. This sound will increase or
decrease in volume depending on the speed
setting of your fan speed control.

Burner Tray:
The burner tray is positioned directly under the
burner tube(s) and logs and is made of a
different gauge material from the rest of the
firebox and body. Therefore, the varying thick-
nesses of steel will expand and contract at
slightly different rates which can cause "tick-
ing" and "cracking" sounds. You should also be
aware that as there are temperature changes
within the unit these sounds will likely re-occur.
Again, this is normal for steel fireboxes.

Blower Thermodisc:
When this thermally activated switch turns ON
it will create a small "clicking" sound. This is the
switch contacts closing and is normal.

Pilot Flame:
While the pilot flame is on it can make a very
slight "whisper" sound.

Gas Control Valve:
As the gas control valve turns ON and OFF, a
dull clicking sound may be audible, this is normal
operation of a gas regulator or valve.

Unit Body/Firebox:
Different types and thicknesses of steel will
expand and contract at different rates resulting
in some "cracking" and "ticking" sounds will be
heard throughout the cycling process.

1) Always turn off the gas valve before

cleaning. For re-lighting, refer to lighting
instructions. Keep the burner and control
compartment clean by brushing and vacu-
uming at least once a year.

When cleaning the logs, use a clean soft
paint brush as the logs are fragile and
easily damaged.

2) Clean glass (never when unit is hot), appli-

ance, door and louvers with a damp cloth.
Never use an abrasive cleaner. The gold
louvers (and optional gold door) may be
scratched if abrasives are used to clean
them.
The heater is finished in a heat resistant
paint and should only be refinished with
heat resistant paint (not with wall paint).
Regency uses Stove Brite Paint - Metallic
Black #6309.

3) Make a  periodic check of burner for proper

position and condition. Visually check the
flame of the burner periodically, making
sure the flames are steady; not lifting or
floating. If there is a problem, call a qualified
service person.

4) The appliance and venting system must be

inspected before use, and at least annual-
ly, by a qualified field service person, to
ensure that the flow of combustion and
ventilation air is not obstructed.

During the annual service call, the burners
should be removed from the burner tray
and cleaned. Replace the embers but do
not block the pilot.

5) Verify proper operation after servicing.

6) Keep the area near the appliance clear and

free from combustible materials, gasoline
and other flammable vapours and liquids.

7) Each time the appliance is lit, it may cause

condensation and fog the glass.  This con-
densation and fog is normal and will disap-
pear in a few minutes as the glass heats up.

8) Periodically check the pilot flames. Correct

flame pattern has three strong blue flames:
1 flowing around the thermopile, 1 flowing
across the rear of the burner and 1 reaching
towards the right (it does not have to be
touching the burner ports.

Incorrect flame pattern will have small, probably
yellow flames, not coming into proper contact
with the rear of the burner or thermopile.