Regency B36X 用户手册

Regency Bellavista™ B36X Gas Fireplace

6)  From the outside top of the fi rebox, remove the intake collar plate 

by removing the 4  - 1/4" x 1/2 " screws.  See Diagram 6.

5) From the outside rear of the fi rebox, remove the intake collar   

assembly.  Remove the  4 - 1/4" x 1/2" screws.  See Diagram 5.

Before proceeding to Step 7, inspect condition of all gaskets.  
     DO NOT install parts with damaged gaskets. Replace if necessary 

with spare gaskets supplied.

7)  From the inside of the fi rebox, place the exhaust assembly into 

position as shown in Diagram 7 and secure with 8 - 1/4" x 1/2" screws 
(Diagram 8).  Ensure all screws are tight, but do not over tighten.  

       All 8 screws must be used.

9)  From the outside rear of the fi rebox, install the intake collar plate 

with 4  - 1/4" x 1/2" screws.  Ensure all screws are tight, but do not 
over tighten.  All 4 screws must be used.

10)  From inside  the fi rebox, re-install the baffl e plate and heat 
    defl ector - reverse steps 2 & 3.

8) From the outside top of the fi rebox, install the intake collar assembly.  

Secure with 4 - 1/4" x 1/2" screws.  Ensure all screws are tight, but 
do not over tighten.  All 4 screws must be used.

The  B36X  uses  the  "balanced  fl ue"  technology Co-Axial system. 
The inner liner vents products of combustion to the outside while the 
outer liner draws outside combustion air into the combustion chamber 
thereby eliminating the need to use heated room air for combustion 
and losing warm room air up the chimney.

The gas appliance and vent system must be vented directly to the 
outside of the building, and never be attached to a chimney serving 
a separate solid fuel or gas burning appliance. Each direct vent gas 
appliance must use it's own separate vent system. Common vent 
systems are prohibited.