Hearth & Home Technologies CASTILE-GAS-MBK 用户手册

September 1, 2008

Page  23

Quadra-Fire · Castile Gas Stove · 7023-111E

Before making gas connections ensure that the appliance 
being installed is compatible with the available gas type.

Any natural or propane gas conversions necessary to meet 
the appliance and locality needs must be made by a quali-
fied technician using Hearth & Home Technologies specified 
and approved parts.

5/32 in. (4mm)  

Allen wrench 

Millivolt Generator

Thermocouple

Pilot Hood

TOOLS REQUIRED:  #2 phillips screwdriver, slotted screw-
driver or Torx TH20, 5/32 in. Allen wrench, 3/32 in. Allen 
wrench, 5/8 in. open end  wrench, 7/16 in. socket, socket 
wrench, and extension.

   Remove front, glass, and logs (if installed). 

 

Remove the optional brick set, if installed.  Remove the two 
screws, one on each side of burner. Retain fasteners for rein-
stallation.  Lift burner up and out of the firebox.

   Pull off the pilot hood and set it aside. 

   Use a 5/32 in. Allen wrench to remove the pilot 

injector. Replace pilot injector with the one supplied with the 
appliance (#35 for Propane, #62 for Natural Gas). Replace 
the pilot hood, snapping into position.

   Remove the main burner orifice using a 5/8 in, 

wrench. Replace orifice with the proper size as indicated for 
your gas type and venting.

 

Reinstall burner by placing it into the firebox.

Installation is the reverse of the removal. Tighten thumb-
screws only finger tight. DO NOT OVERTIGHTEN. Reinstall 
the optional brick set, if applicable.

Reinstall logs, glass and front.

NOTE: Gas conversions should only be performed by a 
qualified service person, and/or where required by state 
and local codes, licensed installer/service technician. In 
the Commonwealth of Massachusetts, installation must 
be performed by a licensed plumber or gas fitter.