Regency Wraps F33 用户手册

下载
页码 28
Regency
®
 F33-3 Freestanding Gas Stove
5
INSTALLATION
10) Installation and any repairs to this appliance should be done by an 
authorised service person. An authorised service person should 
be called to inspect this appliance annually. Make it a practice to 
have all of your gas appliances checked annually.
11) Do not strike the glass door.
12) Under no circumstances should any solid fuels (wood, paper, 
cardboard, coal, etc.) be used in this appliance.
13) The appliance area must be kept clear and free of combustible 
materials, (gases and other fl ammable vapours and liquids).
IMPORTANT
SAVE THESE INSTRUCTIONS
The F33-3 Freestanding Gas Stove must be installed in accordance 
with these instructions. Carefully read all the instructions in this manual 
fi rst. Consult the "authority having jurisdiction" to determine the need 
for a permit prior to starting the installation.
INSTALLATION CHECKLIST
1)  Locate your appliance. Refer to the "Clearance to Combustibles" 
section.
2)  Assemble stove base. Refer to the "Pedestal Assembly" or "Leg 
and Bottom Shield Assembly" sections.
3)  Install fl ueing. Refer to the "Flueing" section.
4)  Make gas and electrical connections. Refer to the "Gas Connec-
tion" section.
 
Test the pilot. Must be as per diagram in the "Pilot Adjustment" 
section.
5)  Test gas pressure. Refer to the "Gas Pipe Pressure Testing"
 section.
6)  Test for fl ue spillage. Refer to the "Test for Flue Spillage"
 section.
7)  Install logs and embers and rockwool where indicated in the "Log 
and Ember Installation" section
8)  Install optional features. Refer to the following sections where 
applicable. 
 
a. Optional Remote Wall Switch
 
b. Optional Remote Control Installation
 
c. Optioanl Wall Thermostat Installation
9)  Final check. Refer to the "Final Check" section. 
Before leaving this unit with the customer, the installer must ensure 
that the appliance is fi ring correctly and operation fully explained to 
customer.
This includes:
1)
  Clocking the appliance to ensure the correct fi ring rate (rate noted 
on label) after burning appliance for 15 minutes.
BEFORE YOU START
INSTALLATION AND REPAIR SHOULD BE DONE BY AN AU-
THORISED SERVICE PERSON. THE APPLIANCE SHOULD 
BE INSPECTED BEFORE USE AND AT LEAST ANNUALLY 
BY AN AUTHORISED SERVICE PERSON. MORE FREQUENT 
CLEANING MAY BE REQUIRED DUE TO EXCESSIVE LINT 
FROM CARPETING, BEDDING MATERIAL, ETC. IT IS IMPERA-
TIVE THAT CONTROL COMPARTMENTS, BURNERS AND 
CIRCULATING AIR PASSAGEWAYS OF THE APPLIANCE BE 
KEPT CLEAN.
DUE TO HIGH TEMPERATURES, THE APPLIANCE SHOULD BE 
LOCATED OUT OF TRAFFIC AND AWAY FROM FURNITURE 
AND DRAPERIES.
WARNING: FAILURE TO INSTALL THIS APPLIANCE COR-
RECTLY MAY CAUSE A SERIOUS HOUSE FIRE AND WILL 
VOID YOUR WARRANTY.
CHILDREN AND ADULTS SHOULD BE ALERTED TO THE 
HAZARDS OF HIGH SURFACE TEMPERATURES, ESPECIALLY 
THE FIREPLACE GLASS, AND SHOULD STAY AWAY TO AVOID 
BURNS OR CLOTHING IGNITION.
  
YOUNG CHILDREN SHOULD BE CAREFULLY  SUPERVISED 
WHEN THEY ARE IN THE SAME ROOM AS THE APPLI-
ANCE.  
CLOTHING OR OTHER FLAMMABLE MATERIAL SHOULD NOT 
BE PLACED ON OR NEAR THE APPLIANCE. 
GENERAL SAFETY
INFORMATION
1)  The appliance installation must conform with local codes or, in the 
absence of local codes, with AS5601-2004 or NZS 5261
2)  The appliance when installed, must be electrically grounded in 
accordance with local codes, or in the absence of local codes with 
the current National Electrical Code, AS 3100
3)  See general construction and assembly instructions. 
4)  This appliance must be connected to a fl ue and terminate to the 
outside of the building envelope. Never fl ue to another room or 
inside a building.
5)  Inspect the fl ue system annually for blockage and any signs of 
deterioration.   
6)  Any safety glass removed for servicing must be replaced prior to 
operating the appliance.
7)  To prevent injury, do not allow anyone who is unfamiliar with the 
operation to use the fi replace.
8)  Wear gloves and safety glasses for protection while doing required 
maintenance.
9)  Under no circumstances should this appliance be modifi ed. Parts 
that have to be removed for servicing should be replaced prior to 
operating this appliance.