Runco RS-900 Series RS1100 Series 用户指南
RS-900 and RS1100 Series Installation/Operation Manual
69
PRE
L
IMINAR
Y
5.1
Lamp Replacement
Lamp Replacement
The lamp should be replaced when it reaches the end of its life (typically 2000 hours), or
sooner if a noticeable degradation in brightness occurs. Contact your Runco dealer to
obtain a replacement lamp.
sooner if a noticeable degradation in brightness occurs. Contact your Runco dealer to
obtain a replacement lamp.
1.
Turn off the projector and unplug the power cord.
Allow the projector to cool down for
approximately 45 minutes prior to removing
the lamp assembly for replacement.
Allow the projector to cool down for
approximately 45 minutes prior to removing
the lamp assembly for replacement.
2.
Loosen the two captive screws from the lamp
cover.
cover.
3.
Remove the lamp cover.
4.
Remove the two lamp assembly mounting screws.
5.
Grasp the lamp assembly handle and pull gently,
removing the lamp module from the projector
housing.
removing the lamp module from the projector
housing.
6.
Install the new lamp module and replace the two
screws.
screws.
7.
Replace the lamp cover at the right side first and
secure it with the two screws.
secure it with the two screws.
8.
5. Maintenance and Troubleshooting