Yamaha TX6n 用户手册

TX6n/5n/4n Owner’s Manual

Network Connection Example

If you connect the TXn units’ [NETWORK] connector to a computer via an Ethernet cable, you’ll be able to mon-

itor/control the TXn units from Amp Editor. Including computers and other equipment, a total of up to 253 units

can be connected in a single network.

• If you wish to connect multiple TXn units, use a network switch that supports 100Base-TX/10Base-T.

• The Ethernet cable between the network switch and the TXn can be up to 100 meters long. Due to the quality of cables and net-

work switch performance, however, proper operation at the maximum length cannot be guaranteed in some cases.

• Since the TXn supports Auto MDI/MDI-X, it will automatically detect whether the connected cable is of the straight type or

crossover type, and will configure itself to create the optimal connection. Therefore, you can use either a straight or crossover
cable.

• To prevent electromagnetic interference, use an STP (Shielded Twisted Pair) cable.

• Refer to the Amp Editor Installation Guide and the Amp Editor Owner’s Manual for information on the TXn initial setup for using

the TXn in a network.

Network switch

Ethernet
cable

Device ID: 1
IP Address: 192.168.0.1

Amp Editor
IP Address: 192.168.0.253

Device ID: 2
IP Address: 192.168.0.2

Device ID: 3
IP Address: 192.168.0.3

Device ID: 4
IP Address: 192.168.0.4

Device ID: 5
IP Address: 192.168.0.5

NOTE