Phase Technology CM5890i 用户手册

Technical data, EASE

™

 plots, SoundTubeSPEC

™

 software & product downloads available at 

   

 

 

Preliminary Technical Information for System Engineers

is an audio system with fewer speakers, 

reduced power needs, shorter installation 

time and cost savings on shipping and labor.
 

Patented SoundTube  

Technologies

  SoundTube entertainment is consis-

tently developing new technologies that 

enhance audio product performance. 

SoundTube Entertainment innovations 

are protected by multiple U.S. and 

international patents, which explicitly 

cover SoundTube dome, enclosure 

mounting and dispersion technolo-

gies.  SoundTube Entertainment actively 

defends its patents in order to protect 

SoundTube resellers and end-users.
 

Technical Data and  

Specification Tools

Technical Data

 

  SoundTube Entertainment strives to 

provide complete and effective technical 

information and data to dealers,  

engineers and designers.  All data are 

available from SoundTube Entertain-

ment or at www.soundtube.com. 

Data Acquisition

 

  All performance data acquired at 

SoundTube’s Technical Measurement 

Center (TMC) are analyzed using a 

variety of standard measurement tech-

niques, including Measured Length 

Sequence (MLS) and Time Delay Spec-

trometry (TDS).  Performance, develop-

ment and data acquisition tools include: 

Gold Line TEF 20, CLIO, LMS, LEAP, and 

proprietary modeling software.  EASE

™

 

data are acquired through an automated 

TEF 20/Outline/EASE

™

 interface.

EASE™ Data

 – 3-D polar plots. 

SoundTubeSPEC™

 – Proprietary 

SoundTube speaker placement software. 

Architectural Specifications

  The loudspeaker shall consist of a 203 

mm (8 in) low-frequency transducer and 

a high frequency transducer with a 1” 

exit and a frequency-dividing network 

installed in a ported enclosure. The low-

frequency voice coil diameter shall be 34 

mm (1.36 in).
  The performance specifications of a 

typical production unit shall be as fol-

lows: Useable frequency response shall 

extend from 63 Hz – 20 kHz (-10 dB, no 

external equalization). Measured sensitiv-

ity (2.83 Volt input, 1 meter) shall be at 

least 95 dB. The speaker shall have a nomi-

nal impedance of 8 Ohms and available 

for 25/70.7/100 Volt modes with a voice 

coil/8 Ohm direct. The frequency-dividing 

network shall have a crossover frequency 

of 2.4 kHz with a slope of 12 dB per octave 

(2nd order). Rated power capacity shall 

be at least 125 Watts continuous power 

(RMS), and shall conform to EIA-426-B 

testing.  Maximum continuous output at 1 

meter shall be 116 dB.
  The low-frequency transducer shall 

have a treated fiber cone and cloth sur-

round. 
  Installation for the CM890i shall be 

by 2-screw blind mount, constant ten-

sion winged assembly and shall attach 

to ceiling thickness tolerances ranging 

from 6.4 mm (0.25 in) to 42.9 mm (1.69 

in). The external wiring input connector 

shall be a 4-pin, 5 mm Euroblock connec-

tor for 8 Ohm or distributed systems and 

shall accept from 10 – 22 gauge wire. The 

maximum backcan dimension shall be 

no more than 201.7 mm (7.94 in) in height