Samson C com 16 用户手册
ENGLISH
18
Tilting and Stacking the C com 16
Installing the Tilting Feet
You can install the tilting rubber feet included with
your C com 16 so that you can set the unit at a com-
fortable operating angle on a workstation or desktop.
Follow the simple instructions below to install the tilt-
ing feet.
your C com 16 so that you can set the unit at a com-
fortable operating angle on a workstation or desktop.
Follow the simple instructions below to install the tilt-
ing feet.
•
Remove the bottom screw from right front
bumper.
bumper.
•
Identify the right tilting foot by the locating “R”
marking on the inside top.
marking on the inside top.
•
Position the angled foot under the right bum-
per as shown in the drawing.
per as shown in the drawing.
•
Use the included 4 x 10mm screw to attach the
foot.
foot.
•
Repeat the steps above for the front left bum-
per.
per.
You can stack one C com 16, or any other Samson C Class units, on top of each other by simply lining up the
bumpers.
bumpers.
Important Note: When stacking the C COM 16, be sure that only the bottom unit has the tilting feet installed.