Toshiba IK-WD01A 用户手册

Status LED

The following table lists the LED patterns in general.

Loading system after power on

Blink green and orange (twice)

During booting procedure

No LEDs illuminated

Detecting and setting network

Steady orange till IP address is 
confi rmed

After network is setup (system up)

Blink orange and red

During the upgrade fi rmware process

Rapidly blink orange till fi rmware is 
upgraded

Reset and restore 

The reset button is located on the back of the Network Camera.  Use this button to 
reset the system or restore the factory default settings.  Sometimes just resetting 
the system sets the system back to a normal state.  If the system problems remain 
after reset, restore to the factory settings and perform the installation again.

RESET: Click on the button. 
RESTORE: 
1.  Continuously press on the reset button until the status LED 

rapidly blinks orange.  It takes about 30 seconds.

2.  Upon  successful  restore,  the  status  LED  will  blink  orange 

and red.

  Restoring the factory defaults will erase any previous settings. Reset or 

restore the system after power on.