Jacuzzi HE97000 用户手册

Comfort Whirlpool Bath

Installation and Operation 

www.jacuzzi.com

 

Page 15

  Install the drain/overflow according to the 

manufacturer’s instructions. Refer also to the 

Technical Specifications Manual.

  Watertight installation of the drain is the installer’s 

responsibility. Drain leakage is excluded from the 

Jacuzzi Luxury Bath warranty of this product.

  Install the faucet at this time. It is recommended that 

the faucet be installed by a qualified plumber.

  Install the flange (purchased separately) according 

to the instructions that are included with the kit. If the 

bathtub is equipped with an integrated flange, skip this 

step.

  Place the bathtub into the niche. Screw the flange to 

the wood stud. It may be necessary to shim the unit 

to close up any gaps between the wood stud and the 

flange.

  Insulation may be placed within the bathtub surround.

  Turn off the power supply to the GFCI protected 

circuit.

  Align the bathtub and connect the drain.

  Connect flex water supply lines to faucet and plug 

power cords into GFCI outlet.

  Inspect all fittings, plumbing, and control lines after 

inserting the bathtub to insure the components are 

not damaged, disconnected, or contacting the finish 

surface substrate or support members.

  Turn on the power supply to the dedicated GFCI 

protected circuits and check system operation.

  Complete all finish work around the perimeter of 

bathtub to seal the space between the rim and the 

finished deck.

Screw

Tile Flange

Tile

Cement Board

Caulking

Stud Wall

Tile Adhesive

Stud 

Mounting 

Screw

1˝ x 4˝  

(not for 

support)

Tile Flange

Silicon/Sealant

Bath Rim

Plastic Filler

Cement Board

Mortar

Stud Wall

1˝ x 4˝ (not for 

support)

Finishing 

Material

If you are installing a integral skirt, please refer to the Skirt 

Installation Guide before proceeding any further. Complete 

the installation and assembly steps according to the Skirt 

Installation Guide.

  Screw skirt flanges into wall studs. 

  It may be necessary to shim the unit to close any 

gaps between wall studs and the flanges.

  Complete finish work over skirt flange.

  Caulk around the perimeter of the skirt to seal the 

 

space between the skirt and the finished deck.

Finishing 

Materials

Caulking Bead

Skirt Panel

Stud

Floor

Green Board

Rim of Bathtub