Associated Equipment 6065 用户手册

下载
页码 4
TO CHARGE BATTERIES: 
This charger is designed to charge all types of 12 volt automotive batteries. The voltmeter scale is color coded to represent the three 
most common types of batteries. 
The GREEN scale represents the proper voltages for CONVENTIONAL batteries. 
The BLUE scale represents the proper charging voltages for RECOMBINATION batteries and LOW MAINTENANCE batteries. The 
YELLOW scale represents the proper charging voltage for MAINTENANCE FREE batteries. 
The RED scale areas indicate the charging voltage is too high and should be turned down, If not turned down, over charging can 
occur to the batteries. 
A CONVENTIONAL battery is one that has accessible filler caps and the plates are lead-antimony construction. A RECOMBINATION 
battery is one that has no filler caps and no free electrolyte. 
A LOW MAINTENANCE battery is one that has filler caps and the plates are a combination of lead-antimony and lead-calcium. A 
MAINTENANCE FREE battery may or may not have filler caps and the plates are lead-calcium. 
If more than one type of battery is charged at one time, use the lowest suggested settings. 
To charge batteries overnight: Adjust charging voltage to 3/4-1 volt less than the recommended highest voltage. Do not exceed 30 
amps. As the batteries charge, the charging current will decrease and the charging voltage increase. The “end of charge” voltage 
should not exceed the maximum suggested value. 
The charging voltage bands are intended to be guidelines to enable the operator to have a starting point to charge batteries. The age 
of the batteries, temperature, and type of batteries will affect the charging cycle. The best setting for your charging conditions will 
have to be determined by experience. 
 
END OF CHARGE: 
Discontinue charging when specific gravity reading does not change in 3 consecutive readings, battery is freely gassing or when the 
electrolyte reaches 120˚F. If your battery is sealed and these determinations cannot be made, see manufacturers instructions for 
charging. 
 
 
 
MODEL 6065 PARTS LIST 
 
605675 Switch w/knob (1) 
610057 Handle (Optional Accessory) 
 
605632 Ammeter 
610253 Side Panels (1 Pr.) 
 
610058 Voltmeter 
610075 Top Panel 
 
605206 A.C. Cord 
610076 Base 
 
605628 D.C. Cable Set 
610081 Front Panel 
 
610122 Rectifier Assembly 
610082 Back Panel 
 
610069 Circuit Breaker 
610097 Transformer
 
 
 
 
If you elect to order parts from the factory you may do so by mail or phone. Minimum order from the factory is $25.00. Orders received 
that are under the minimum will not be processed. Taxes and freight are extra and are not considered to be part of the dollar value of 
the order. We do not have a COD. policy. Cashier check, money order, Master Card or Visa are acceptable. If you use a Master Card 
or Visa Card send only the number and expiration. Do not send the card. 
 
 
 
 
 
ASSOCIATED EQUIPMENT CORP. 
5110 Brown, St. Louis, Mo. 63115 
Phone (314) 385-5178 
027-0017 
ECN 1712 
Rev. 11/87