Toshiba B-SV4D-GS 用户手册

 

- 174 - 

If the printer detects any of the following errors, it will display the error message (LED), makes status 

response (serial interface, parallel interface and USB interface), and stops its operation. 

 

(1) Command 

Errors 

 

An error results if a command length error, command transmission sequence error, command 

format error or parameter designation error is found in analyzing the command.  An error results if 

the Format Command of a field is not transmitted and its Data Command is transmitted.  When 

attempting to call a PC Save Command of a save identifier which is not saved, an error results.  

An undefined command is not detected as an error, and data is discarded until [NUL] or [}] is 

received. 

(2)  Hardware Errors 

 

An error results if a framing error, overrun error or parity error is found during data reception when 

using the serial interface (RS-232C). 

 

* At the moment when a command error or hardware error occurs, the printer shows the error 

message and makes status response before stopping.  The Status Request Command and 

Reset Command only can be processed and other commands are not processed.  When the 

printer is restored by the [RESTART] key, the printer enters the initial state which is obtained 

after the power is turned on. 

 

(1) Feed 

Jam 

 

c

  When the relation between the programmed label (or tag) pitch (A) and the label (or tag) pitch 

detected by the sensor (B) is not indicated by the following formula, an error will result: (A) × 

50% 

≤

 (B) 

≤

 (A) × 150% 

 

 

• A paper jam has occurred during paper feed. 

 

 

• The paper is not placed properly. 

 

 

• The actual label does not match the type of the sensor. 

 

 

• The sensor position is not aligned with the black mark. 

 

 

• The actual label size does not meet the designated label length. 

 

 

• No label-to-label gap is detected due to preprint. 

 

 

• The sensor is not thoroughly adjusted.  

(The sensor is not adjusted for the label to be used.) 

 

d

  If the stripped label does not cover the strip sensor when printing or feeding is completed in 

strip mode, an error will result.