Ricoh 1008 用户手册
Condition Cause
Remedy
See
Page
Power cord is not properly
Plug it in firmly.
-
plugged into the outlet.
Nothing happens
Check that the both ends of
when the switch is
the top unit are securely
turned on.
Top unit is not completely
closed. If not, close the top 15
closed. unit firmly by pressing the
marked position.
is displayed on
the copy counter.
Paper cassette is empty. Load paper.
18
is
blinking.
Toner has nearly run out
Replace toner cassette.
42
stays
on.
Toner has run out. Replace toner cassette.
42
stays
on.
A misfeed has occurred. Clear misfed paper.
59
The copier has
entered Auto-off
mode (30 minutes
The copier has shifted to the Press any key to re-activate
after a copy was
Auto-off function.
the copier. 21
made or a key was
pressed).
Copies have white
streaks.
Corona wires are dirty. Clean the corona wires.
45
Copy image
density is uneven.
displayed on
Wait for a while until the
the copy counter.
The copier is overheated.
copier cools down and
is
48
no longer displayed.
ATTENTION: If the error code (E ..) appears, turn off the main switch,
then turn it on. If the error code disappears, the copier
will function. If the error code appears again, turn off the
main switch and immediately call your service personnel.
main switch and immediately call your service personnel.
56