Toshiba E-STUDIO555 用户手册
1.BEFORE USING EQUIPMENT
Placing Paper 13
1 BEFORE USING EQUIPMENT
Placing paper in drawers
Follow the procedure below to place paper in a drawer. For acceptable copy paper, see the following page:
1
Turn the power of this equipment ON.
2
Pull out a drawer carefully until it comes to a stop.
Be careful not to touch the slide rails (A in the figure).
This could injure you.
This could injure you.
3
Push the lower part of the end guide in the direction
of the arrows to remove it, then reinstall it at the
position of the desired paper size.
of the arrows to remove it, then reinstall it at the
position of the desired paper size.
The paper size is indicated on the bottom inner surface of the
drawer.
drawer.
4
Push the part shown with an arrow (right side) of the
side guide to unlock it.
side guide to unlock it.
5
While holding the green lever of the side guide in the
direction of the arrow, set the side guide to the
desired paper size.
direction of the arrow, set the side guide to the
desired paper size.
y
The paper size is indicated on the bottom inner surface of the
drawer.
drawer.
y
Adjust the side guides with both hands.
A