Toshiba E-STUDIO555 用户手册

36    Bypass Copying

When you make copies on OHP film, sticker labels or non-standard size paper, place the copy paper on the bypass tray. 
Bypass copying is also recommended for copying on standard size paper which is not set in any of the drawers.

If you select the paper size, you can utilize various functions such as the automatic paper selection (APS) or the 
automatic magnification selection (AMS). For details, see the following page:

The operating procedure for bypass copying differs depending on the paper size to be used. See the table below for the 
operating procedure of each size.

y

Bypass copying stops when the paper placed on the bypass tray runs out during copying, even if the paper of the 
same size is in any of the drawers. Copying restarts when paper is supplied to the bypass tray.

y

When bypass copying has been completed, the [FUNCTION CLEAR] button on the control panel blinks. Press this 
button to switch bypass copying to normal copying using the drawers. 
(Even if you do not press the [FUNCTION CLEAR] button, bypass copying will be switched to normal copying using 
the drawers when the current status is cleared by means of the automatic function clear after a specified period of 
time.)

Open the bypass tray for bypass copying.

If the paper is large, pull out the paper holder.

Standard size

Other than North America: 
A3, A4, B4, B5
North America: LD, LT, LG, 
ST-R

Other than the above

Others (Non-standard sizes)