Toshiba e-STUDIO211c/311c 用户手册
1
2
3
4
5
6
7
8
9
10
11
12
9-3
2. ADD PAPER SYMBOL
Adding Paper to the Drawers
When the paper supply in the selected drawer or the large-capacity feeder (optional) runs out, the
drawer or large-capacity feeder shown on the display flashes, and the following message appears:
drawer or large-capacity feeder shown on the display flashes, and the following message appears:
Add paper
Add paper as follows.
1
While pulling up the drawer grip, draw out the drawer
carefully until it comes to a stop.
2
Place paper in the drawer.
- Maximum number of sheets that can be set
Page 2-4
- Fan the paper well before placing it in the drawer.
- Do not add paper above the line indicated on the guide.
- Do not use creased, folded, wrinkled or damp sheets of
paper.
Make sure that a gap of approx. 0.5 mm (less than 1 mm in
total) is left between the paper and the side guide. If there is
no gap, this would cause paper misfeeding.
total) is left between the paper and the side guide. If there is
no gap, this would cause paper misfeeding.
Limit line
0.5mm
0.5mm
Side guide
Side guide
3
Push the drawer straight in until it comes to a stop.
- Be sure to push the drawer fully in.
Caution
Be careful not to let your fingers be caught when closing the
drawer.
This could injure you.
drawer.
This could injure you.