Enterasys Networks 7H4385-49 用户手册
Backplane Connections and Installation Rules
3-4 Installation
These DFE modules have connections to both FTM1 and FTM2 backplanes, enabling them
to route frames between the two backplanes and all modules in the 6C107 chassis.
However, the older first (6x1xx), second (6x2xx), and third (6x3xx) generation modules
are still managed using their own Local Management and are not subject to management
by the DFE module management entity.
to route frames between the two backplanes and all modules in the 6C107 chassis.
However, the older first (6x1xx), second (6x2xx), and third (6x3xx) generation modules
are still managed using their own Local Management and are not subject to management
by the DFE module management entity.
The Matrix N1 (7C111), Matrix N3 (7C103) and Matrix N7 (7C107) chassis have only FTM2
connections and support only DFE modules. The Matrix N5 (7C105‐P) has FTM2
connections and also supports PoE‐compliant DFE modules.
connections and support only DFE modules. The Matrix N5 (7C105‐P) has FTM2
connections and also supports PoE‐compliant DFE modules.
Module Placement and Installation Rules
The DFE‐Platinum modules can be installed in a Matrix E7 (refer to
below, for placement rules), Matrix N1, Matrix N3, Matrix N5, or
Matrix N7 chassis. The Matrix N1, Matrix N3, Matrix N5, and Matrix N7 chassis support
only DFE Series modules and there are no particular rules for installing modules.
only DFE Series modules and there are no particular rules for installing modules.
Matrix E7 Chassis Module Placement
Depending on the modules being installed in the Matrix E7 chassis and to help ensure
proper operation, consider the following examples and rules for module placement in the
chassis.
proper operation, consider the following examples and rules for module placement in the
chassis.
shows six examples of chassis module placement. These examples are
described below along with the applicable module placement rule.
Figure 3-1 Examples, Module Placement in Matrix E7 Chassis
Example 1 (
A)
Shows the chassis fully populated with DFE modules (7xxxxx). These modules
communicate with each other via the FTM2 chassis backplane and act as a single
switching entity with one IP address. The DFE modules are configured using a Command
Line Interface set of commands.
communicate with each other via the FTM2 chassis backplane and act as a single
switching entity with one IP address. The DFE modules are configured using a Command
Line Interface set of commands.
Rule: DFE modules can be installed in any available chassis slot in the Matrix E7 chassis.
7XXXXX
7H43X-XX
6X3XX
6X3XX
6X2XX
6X1XX
1 2 3 4 5 6 7
6X1XX
6X2XX
+
6X3XX 6X3XX
1 2 3 4 5 6 7
6X1XX
6X2XX
1 2 3 4 5 6 7
6X3XX
1 2 3 4 5 6 7
7XXXXX
1 2 3 4 5 6 7
1 2 3 4 5 6 7
6X3XX
6X3XX
6X2XX
7XXXXX
6X1XX
A
E
D
C
B
F