3M 11-81375-227 用户手册

3M™ MicroTouch™ Display M1500SS User Guide 

11 

3M Touch Systems, Inc. Proprietary Information 

Document #19-258 

Rev AH 

This chapter describes how to set up and integrate your 3M

TM

 MicroTouch

TM

 M1500SS 

Display into a touch application system. You need to complete the following tasks: 
• Unpack the components 

• Connect the video and power cables to your computer

• Power on the display and test your setup 

• Install the MT 7 software then connect the sensor cable 

• Calibrate the touch sensor 

The M1500SS Display requires a personal computer (PC).  This touch display will not 
work with Apple Macintosh computers. 

The requirements for your PC are as follows: 

• Your PC must have an available RS-232 serial communication (COM) port or USB 

port.  You connect the touch sensor to this port. 

• Your PC must have a video card and video driver already installed for the display.  If 

you need to install a video card or a video driver, refer to your computer 
documentation for instructions. 

• Your PC must have a unique interrupt request (IRQ) available to the touch sensor 

COM port.  The touch sensor cannot share an IRQ with another device. 

When choosing your workspace, select a sturdy, level surface.  Also, make sure you can 
easily access the back of the touch display and the computer.  Easy access helps ensure a 
smooth setup of the touch display. 

Note:  Before setting up your M1500SS Display, refer to the Important Safety 
Information section at the beginning of this document.