Intel 1520 用户手册

Intel NetStructure Cache Appliance Administrator’s Guide

✔ The appliance handles node failure in WCCP cache farms. If one node goes 

down, its load is redistributed among the remaining nodes. 

✔ In WCCP, you can use multiple routers. Traffic flowing through multiple 

routers can share the same pool of caches.

In Figure 4, appliances 1, 2, and 3 form a WCCP cache farm.

If the appliance in the WCCP-enabled routing scheme has an ARM bypass rule, 
the rule causes the appliance to forward particular client requests directly to the 
origin server, bypassing the appliance. Bypassed requests are unchanged by the 
ARM; they retain their client source IP addresses. See Adaptive interception 
bypass‚ on page 126 for details. 

In WCCP 2.0, you can exclude certain router interfaces from redirection. The 
appliance bypass rules can work if you exclude the router interface on which it is 
connected from using WCCP. To do so, set the router configuration command 

ip 

wccp redirect exclude in 

(refer to Cisco’s WCCP documentation for 

information about router configuration).

If a WCCP router serves several nodes, as in Figure 4, the router balances their 
loads. The router sends each node requests aimed at a particular range of IP 
addresses, so that each node is responsible for caching content residing at 
particular IP addresses.

The appliance also supports cache affinity. If a node fails and then restarts, the 
appliance returns the node to its former load distribution. The node’s cache need 
not be repopulated.

The WCCP cache farm acts as a simple form of distributed cache. A WCCP-
enabled network device distributes traffic to individual appliances based on the IP 
address of the destination Web server. Each node caches objects requested from a 
particular set of Web servers, which belong to that node’s assigned range of 
destination IP addresses. 

If you are running clustered appliances, Intel recommends that you do not enable 
virtual IP failover in WCCP environments. The appliance’s WCCP failover 
mechanism handles node failures and restarts. See Virtual IP failover‚ on 
page 146 for details about virtual IP failover. 

Instead of the WCCP protocol, you can use the policy-routing capabilities of a 
router to send traffic to the Intel NetStructure Cache Appliance. WCCP or an L4 
switch is generally preferable to policy-based routing because it has a 
performance impact on the router and does not support load balancing or 
heartbeat messaging.