Fujitsu 480 用户手册
8-222
C122-E003-02EN
GSWB
CHAPTER 8 CLI Operations
CHAPTER 8 CLI Operations
• % Invalid input detected at '^' marker.
Cause: Invalid character detected at '^' marker in the entered command string
Action: Enter the command string correctly.
• System error.
Cause: An internal error occurred.
Action: Check the system status, and reenter the command. If the error occurs again,
collect unit information, configuration definition information, and the
information in different types of logs, and restart the unit. Alternatively,
contact a certified service engineer.
information in different types of logs, and restart the unit. Alternatively,
contact a certified service engineer.
8.3.6
Bridge-related commands
8.3.6.1 show bridge
This command displays the learning table contents.
The displayed contents include Dynamic entries and Static entries.
The command cannot be executed during execution of any of the following
commands:
commands:
z clear bridge
z This command
z This command
Any change in the learning table is reflected in the displayed information after about 5
to 10 seconds.
to 10 seconds.
(1) Synopsis
• Displays the learning table contents
(2) Options
z <interface-id> (optional): Specifies the interface of the contents to be displayed.
- GigabitEthernet 0/1-8
- IO_Unit 0 0-7 1
- TenGigabitEthernet 1/1-2
- port-channel 1-7
- IO_Unit 0 0-7 1
- TenGigabitEthernet 1/1-2
- port-channel 1-7
show bridge {[<interface-id>] | address <address>}
| [vlan <vlan-id>] | [status <status>] | [chip <chip no>]}
| [vlan <vlan-id>] | [status <status>] | [chip <chip no>]}