Toshiba A300D 用户手册

下载
页码 218
User’s Manual
ix
2
The user manual of analog equipment must contain the equipment’s 
Ringer Equivalence Number (REN) and an explanation notice similar 
to the following:
The Ringer Equivalence Number (REN) of the modem, which can vary. 
For the REN of your modem, refer to your modem’s label
.
3
The standard connecting arrangement (telephone jack type) for this 
equipment is jack type(s): USOC RJ11C.
The IC registration number of the modem is shown below.
Canada: 4005B-DELPHI
               109AH-ML3054
                3652B-RD02D330
Notes for users in Australia and New Zealand
Modem warning notice for Australia
Modems connected to the Australian telecoms network must have a valid 
Austel permit. This modem has been designed to specifically configure to 
ensure compliance with Austel standards when the country/region selection 
is set to Australia. The use of other country/region setting while the modem 
is attached to the Australian PSTN would result in you modem being oper-
ated in a non-compliant manner. To verify that the country/region is cor-
rectly set, enter the command ATI which displays the currently active 
setting. 
To set the country/region permanently to Australia, enter the following com-
mand sequence:
AT%TE=1
ATS133=1
AT&F
AT&W
AT%TE=0
ATZ
Failure to set the modem to the Australia country/region setting as shown 
above will result in the modem being operated in a non-compliant manner. 
Consequently, there would be no permit in force for this equipment and the 
Telecoms Act 1991 prescribes a penalty of $12,000 for the connection of 
non-permitted equipment.
The Ringer Equivalence Number (REN) assigned to each terminal device 
provides an indication of the maximum number of terminals allowed to be 
connected to a telephone interface. The termination on an interface may 
consist of any combination of devices subject only to the requirement that 
the sum of the Ringer Equivalence Numbers of all the devices does not 
exceed 5.