RuggedCom RX1100 用户手册
Chapter 4 – Configuring Networking
This menu allows you to configure a dummy interface. Normally the router is
reachable on any of its interface addresses, whether the interface is active or not.
When OSPF and link detection is used, inactive interfaces are not advertised to the
network and thus not reachable. A dummy interface is always advertised and thus
reachable.
reachable on any of its interface addresses, whether the interface is active or not.
When OSPF and link detection is used, inactive interfaces are not advertised to the
network and thus not reachable. A dummy interface is always advertised and thus
reachable.
Routing And Gateways
Figure 35: Routing And Gateways
This menu allows you to configure the default gateway address and static routes.
Static routes specify a way to forward subnets of traffic that cannot be associated with
the subnets of configured interfaces. The gateway address is the address that is used
to forward traffic that can not be routed to configured interfaces or to static routes.
This menu also allows user to convert manually entered static routes to permanently
configured static routes.
Static routes specify a way to forward subnets of traffic that cannot be associated with
the subnets of configured interfaces. The gateway address is the address that is used
to forward traffic that can not be routed to configured interfaces or to static routes.
This menu also allows user to convert manually entered static routes to permanently
configured static routes.
Default Route Table
The first table of this menu configures the default gateway address.
Note: Don't configure a default gateway if you plan to provide one from a WAN,
PPPoE or modem interface. Don't manually configure configure the default gateway
in the /etc/network/interfaces file, configure the default gateway from this menu.
If the default gateway is configured but the actual default gateway in use is different,
the menu will display a warning accompanied by the actual gateway. Use the Save
button below the table to change the default gateway setting.
the menu will display a warning accompanied by the actual gateway. Use the Save
button below the table to change the default gateway setting.
Configured Static Routes
This table configures static and host routes.
RuggedCom 51