Ricoh PJ S2130 用户手册

English

45

English

The projector will detect the lamp life itself.  It will show you a 

warning message 

 

When you see this message, change the lamp as soon as pos-

sible. Make sure the projector has been cooled down for at 

least 60 minutes before changing the lamp. 

Warning: To avoid 

burns, allow the 

projector to cool for 

at least 60 minutes 

before you replace the 

lamp!

Warning: To avoid the 

risk of personal injury, 

do not drop the lamp 

module or touch the 

glass parts. The glass 

parts may shatter and 

cause injury if it is 

dropped.
Warning: For contin-

ued safety replace with 

a lamp of the same 

type.
Caution: If the lamp 

should break, handle 

with care to avoid 

injury due to broken

pieces and contact your 

sales representative for 

repair service.

 

1.   Switch off the power to the projector by pressing the  

“Power”.

 

2.  Allow the projector to cool down at least 60 minutes.

 

3.  Disconnect the power cord.

 

4.  Use a screwdriver to remove the 2 screws from the cover. 

5.  Push up and remove the lamp cover. 

6.   Loosen the 2 screws from the lamp module  and pull up  

the lamp bar. 

 

7.   Pull out the lamp module by force. 

 

8.    Install the new lamp module by reversing the previous steps. 

 

 See the lamp’s  manual for instructions on resetting the lamp 

time.

 

 Used Lamps 



This projector’s lamp contains trace amounts of environmentally 

harmful inorganic mercury. Be careful not to break used lamps, 

and dispose of them in accordance with local regulations or con-

tact your sales representative.