Toshiba TLP-S40 用户手册

41

40

Loosen the 2 screws, then pull up to the
direction of the arrow with your fingers on the
area shown in the figure to remove the lamp
cover.

Loosen the 2 screws holding the lamp in place,
and pull up the handle to remove the lamp.

Align the orientation, press down until the bottom is
reached, and lock in place using the two lamp
locking screws.

Align the cover, and press it in, then tighten the
screws loosened in step 

 until the lamp cover is

no longer loose.

See the lamp’s manual for instructions on resetting
the lamp timer.

• Press the 

 button twice to display (a rough guide) the time of lamp use, the Lamp time

item, in the Status display menu. 

• It is recommended that the lamp should be replaced after 3,000 hours of use. When

Lamp time reaches 3,000 hours, the 

 icon and a message will appear. This display

disappears when you press 

 button.

• Attach the lamp cover correctly so that it is not loose. If it is not attached correctly, the

lamp may fail to come on 

, and the lamp’s lifetime may be shortened.

• Always replace the lamp with a new one.
• The lamp is made out of glass. Do not touch the glass surface with your bare hands,

bang it, or scratch it. (Dirt, jolts, scratches and the like could break the lamp.)

This projector’s lamps contain trace amounts of environmentally harmful inorganic
mercury. Be careful not to break used lamps, and dispose it in accordance with local
regulations.

2

1

2

1

1

2

• Request cleaning and maintenance of a ceiling-mounted unit from your projector dealership.

■ Lens cleaning

• Clean the lens with a commercially available blower and/or

lens cleaner.

• The lens is easily scratched, so do not rub it with hard objects,

or strike it.

■ Main unit cleaning

• Clean the main unit after unplugging the power cord.
• Wipe dirt off the main unit gently with a soft cloth.
• If the soiling is severe, dip the cloth in a neutral

detergent diluted in water, wring well, and gently wipe
off the dirt, then finish up by wiping with a dry cloth.

● Replacing air intake and exhaust fans, and air filter

To maintain the performance, it is recommended that these should be replaced about
every 2 to 3 years. Consult with your dealer for details.

A lamp is consumable supplies. If used for extended periods, images will appear dark, and
the lamp could burn out. This is characteristic of a lamp, and is not malfunction. (The lifetime
of the lamp depends on condition of use. If this happens, replace it with a new one.

• If the projector is mounted on a ceiling, request a lamp replacement from your projector dealership.
• When replacing, always use lamp “TLPLV2” (sold separately).

• If you have been using the projector, the lamp will be very hot, and may cause burn injuries.

Wait for the lamp to cool (for longer than 1 hour) before replacing it.

• If the lamp should break, please handle with care to avoid injury due to broken pieces

and contact your dealer for repair service.

Wait for at least 1 hour.