Toshiba TLP-T601 用户手册

59

58

Loosen the screws, then pull up to direction of
the arrow with your fingers on the area shown
in the figure to remove the lamp cover. Be
careful to avoid breaking a nail or otherwise
injuring your fingers when doing so. (If the
screws are too tight to remove the lamp cover,
use any tool.)

Loosen the 2 screws holding the lamp in place,
and pull on the handle to remove the lamp.

Align the orientation, press down until the bottom is
reached, and lock in place using the two lamp
locking screws.

Align the cover, and press it in, then screw in the
screws loosened in step 

 until the lamp cover is

no longer loose.

See the lamp’s manual for instructions on resetting
the lamp timer.

• Press the 

 button twice to display (a rough guide) of the time of use from the Lamp

time item on the Status display menu. 

• As a rule of thumb, it is recommended that the lamp should be replaced after 2,000

hours of use. When Lamp time reaches 2,000 hours, the 

 icon and a message will

appear. When any operation is performed, the message disappears.

• Attach the lamp cover correctly so that it is not loose. If it is not attached correctly, the

lamp may fail to come on 

, and the lamp’s lifetime may be shortened.

• Always replace the lamp with a new one.
• The lamp is made out of glass. Do not touch the glass surface with your bare hands,

bang it, or scratch it. (Dirt, jolts, scratches and the like could break the lamp.)

This projector’s lamps contain trace amounts of environmentally harmful inorganic
mercury. Be careful not to break used lamps, and dispose it in accordance with local
regulations.

This chapter briefly describes how to use supplied software applications other than the
Wireless utility.

■ How to use the Projector Configuration Tool

The Projector Configuration Tool is a software utility that allows you to set up the
projector for Infrastructure mode communications using a wireless LAN PC card.
When using this application for the first time, conduct Preparation 

, and start with

the computer in Ad hoc transmission mode.

The MAC address is a unique address assigned to the wireless LAN PC card.
Display the MAC address on the screen, referring to “Displaying Information” 

.

Note down the address for future use.

Upon launch, the window shown in the figure to the
right appears on the computer screen.

The computer starts searching for projectors. When it
finds one, “Please select” is displayed in the
Projector Selection field.

Click on the 

 button for the Projector Selection

field, then from the pull-down list that is displayed,
select
the project with the MAC address you noted down in
step 

.

When a projector is selected, the computer obtains
information from that projector, and displays the results
in the boxes of the window.

Here, the following is possible:

From the File menu, select Save As..., and save the pre-modification settings on the
computer.
From the File menu, select Open, and apply an existing settings file to the projector.

2

1

2

1

1

2