Toshiba X2500 用户手册

25

24

Operations

■ Connecting the power cord

The ON/STANDBY indicator will
change to orange, indicating standby
mode.

■ Removing the lens cover

Be sure to remove the lens cover when the power is
turned on. If it is left on, it could become deformed due
to heat.

■ Turning the power on

When the beep sound is [On], the
projector beeps, the power turns on,
and the ON/STANDBY indicator lights
in green. After a moment, the start-up
screen appears.

• Do not look into the lens while the lamp is on.  The strong light from the lamp may cause

damage to your eyes or sight.

• Do not block the air intake or exhaust. Doing so could cause a fire due to internal overheating.
• Do not place your hands, face, or other objects near the air exhaust. Doing so could cause

burns, deform/break the object.

Power cord connector
(Supplied)

• When COMPUTER 2 IN terminal (also used for MONITOR OUT terminal) is used as

MONITOR OUT terminal, the signal which is input to COMPUTER 1 IN terminal is output.

• Signals are output from MONITOR OUT terminal even in standby mode.
   However, from AUDIO OUT terminal, no audio signal is output.
• A computer monitor cannot accept Y/P

B

/P

R

 signals correctly.

• The AUDIO IN terminal doubles for devices connected to COMPUTER 1 terminal and

COMPUTER 2 terminal.

• When an AUDIO OUT terminal is connected, sound is not output from the projector

speaker.

• Output volume of AUDIO OUT terminal can be adjusted by the VOL button.
• Moving pictures played back on computers using DVD software may appear unnatural if it

is projected with this projector, but it is not a malfunction.

Caution – use of controls or adjustments or performance of procedures other than
those specified herein may result in hazardous radiation exposure.

TLP-X2500

TLP-XC2500

TLP-XC2500