Toshiba GA-1040 用户手册
1
1-11
Ethernet cable connection
Ethernet cable connection
The GA-1040 supports Ethernet cabling with Unshielded Twisted Pair (UTP) cable
and Shielded Twisted Pair (STP), defined as Category 5 for use with 100BaseT or
defined as Category 3 or Category 5 for use with 10BaseT. The cable plugs into the
RJ-45 socket on the GA-1040.
and Shielded Twisted Pair (STP), defined as Category 5 for use with 100BaseT or
defined as Category 3 or Category 5 for use with 10BaseT. The cable plugs into the
RJ-45 socket on the GA-1040.
N
OTE
:
The 100BaseT type supported by the GA-1040 is 100BaseTX, also known as
Fast Ethernet. If an Ethernet hub is used, it must be a 100BaseTX hub. The term
“100BaseT” is used in this manual to refer to 100BaseTX.
“100BaseT” is used in this manual to refer to 100BaseTX.
Back view with GA-1040 installed
Shut down the copier before attaching the GA-1040 to any network device.
T
O
USE
UTP/STP
CABLE
FOR
100B
ASE
T
OR
10B
ASE
T
1.
With the copier turned off, connect the RJ-45 connector to the RJ-45 socket on the
back of the copier.
back of the copier.
2.
Configure network servers for printing and then proceed to Setup.
Parallel connector
RJ-45 connector for Ethernet
!