Toshiba B-SX5T-TS22-QM-R 用户手册

2. PRINTER SETUP

ENGLISH VERSION EO1-33059

2.4 Loading the Media

E2- 6

2.4 Loading the Media

(Cont.)

10. Lower the Print Head Block until it stops.
11. After loading the media, it may be necessary to set the Media

Sensors used to detect the print start position for label or tag printing.

Setting the Feed Gap Sensor position

(1) Remove the Locking Screw that secures the Media Sensor.
(2) Manually move the Media Sensor so that the Feed Gap Sensor is

positioned at the centre of the labels. ( indicates the position of
the Feed Gap Sensor).

(3) Tighten the Locking Screw.

Setting the Black Mark Sensor position

(1) Remove the Locking Screw that secures the Media Sensor.
(2) Pull about 500 mm of media out of the front of the printer, turn the

media back on itself and feed it under the Print Head past the sensor
so that the black mark can be seen from above.

(3) Manually move the Media Sensor so that the Black Mark Sensor is

in line with the centre of the black mark on the media. ( indicates
the position of the Black Mark Sensor).

(4) Tighten the Locking Screw.

NOTE:

Be sure to set the black mark
sensor to detect the centre of the
black mark, otherwise a paper
jam or no paper error may occur.

Locking Screw

Black Mark Sensor

Black Mark

Feed Gap Sensor

Label

Gap

Locking Screw

Media Sensor