SATO 10e 用户手册
SATO M10e Service Manual
PN: 9001113A
Page 4-1
4
ACCESSORIES INSTALLATION
The following procedures provide in-depth instructions on the installation of all optional
accessories. Each accessory is a purchase option that may not apply to your setup. Refer to the
list below to determine if any are applicable and their installation is required. If not, disregard this
section of the manual and proceed to the next.
accessories. Each accessory is a purchase option that may not apply to your setup. Refer to the
list below to determine if any are applicable and their installation is required. If not, disregard this
section of the manual and proceed to the next.
LABEL CUTTER INSTALLATION
This procedure only applies to the physical installaiton of cutter assembly hardware. Refer to
other procedures for configuration, etc.
other procedures for configuration, etc.
1 Switch off the printer and disconnect the power supply cord.
2 Remove the top, front, left, and right housing covers.
2 Remove the top, front, left, and right housing covers.
3 Remove three screws (1, Figure 4-1a) securing tear-off plate (2) to printer frame (3).
Figure 4-1a, Cutter Installation
NOTE: Figure 10-1 in the Diagrams & Schematics section provides guidance
on housing cover removal.
on housing cover removal.
2
1
1
3