FARGO electronic Pro-L 用户手册

Card Laminating

Section 5: Card Laminating 27

A. ABOUT THE LAMINATOR

In addition to printing and applying the standard clear overlay panel included on

the various ribbon types, the printer also provides a built-in lamination system for

applying a more secure, tamper-resistant overlaminate. This built-in laminator is

controlled by both the printer itself and the printer’s software driver. 
Upon initial power up of the printer, you will notice that the bottom line of the

LCD display will read Lam Adjust Temp. This indicates that the laminator is

heating up to its preset, or default laminating temperature of approximately 300° F

(150° C). This heating process will generally take about 3-4 minutes before the

laminator is heated to the default temperature. Once the laminator reaches its

default temperature, the LCD display will change to Lam Ready. Note that the

LCD display will read Lam Adjust Temp whenever the laminator is heating up or

cooling down to the prescribed temperature.
If you wish to change the temperature of the laminator, you can adjust its

temperature through the Lamination controls within the printer driver setup

window (see Section 6-D). Once adjusted, the new temperature settings will be sent

down with the next print job along with the rest of the printer driver information.

Before printing begins, the laminator will automatically adjust itself to the new

temperature setting. This new temperature setting will remain programmed within

the printer until it is once again changed within the printer driver or until the

printer is turned OFF. Whenever the printer is turned OFF, the laminator will

automatically reset itself and return to its default temperature the next time the

5

proL.qxd  8/6/2000  3:30 PM  Page 27