Fujitsu fi-6800 用户手册

This Acrobat version does not support Windows

®

 

2000 and Windows Server

®

 2008.

Place the scanner at its installation site.

The following describes how to connect the cables 
between the scanner and your computer.

Make sure that the computer is turned 
OFF.

Connect the scanner to your computer 
either with a USB or SCSI cable.

The following describes the requirements for 
connecting with the respective cables.

z

USB cable

-Be sure to use the USB cable which comes 

as an accessory with this scanner.

-When connecting to an USB hub, use the 

first stage USB hub that is closest to the 

computer. If you use the second or later hub 

stages, the scanner may not operate cor-

rectly.

-If you connect the scanner with USB 2.0, it 

is required that the USB port and the hub be 

compliant with USB 2.0. The scanning 

speed slows down when you connect the 

scanner with USB 1.1.

z

SCSI cable

-When using the scanner with a SCSI inter-

face, the following types of SCSI cable and 

SCSI card must be purchased.
SCSI cable:

Use a SCSI cable whose connector on the 

computer side mates to the connector on 

the SCSI card installed on your computer. 

On the scanner side, use either of the fol-

lowing SCSI cable types depending on the 

connector (1 or 2) used:
SCSI Connector 1: 50-pin high-density type

SCSI Connector 2: 68-pin high-density type

Find the recommended SCSI card informa-

tion on the Fujitsu website (FAQ):

-In a SCSI daisy chain formation, connect 

the scanner so that it is the terminated 

device.

z

The scanner weight is 32 kg (70.56 lb). 

You must not carry it alone.

z

Carry the scanner by supporting it from 

the bottom.

350

3

35

50

350

430

430

460

460

(12.20)

(12.20)

310

460

460

(18.11)

430

(16.93)

Scanner’s Dimensions

Installation Space

Unit: mm (in.)

1

2

3

SCSI ID

 CGA Board (when Kofax VRS is used)

SCSI Connector 2

USB Connector 1

USB Connector 2

SCSI Connector 1

SCSI Cable

USB Cable

Power Cable

z

You cannot make both USB and 

SCSI cable connections at the 
same time.

z

You cannot connect multiple 

computers to the scanner at the 
same time.

z

To scan using TWAIN/ISIS, connect 

the cable to USB Connector 1 or 
SCSI Connector 1 on the scanner. 
To scan using Kofax VRS, connect 
the cable to USB Connector 2 or 
SCSI Connector 2 on the scanner.

z

Turn off the scanner and your 

computer whenever you switch the 
interface cable.

Be careful not to damage any pins of 
the SCSI connector when connecting 
the scanner to your computer.