Jet Tools J- A5818 用户手册

 

6

1.  All work shall be secured using either clamps or 

a vise to the drill press table.  It is unsafe to use 
your hands to hold any workpiece being drilled.   

2.  Drill press head and table shall be securely 

locked to the column before operating the drill 
press.  This must always be checked prior to 
starting the machine.   

3.  Always use the correct tooling.  Tooling shall 

always be maintained and properly sharpened.  
All tooling must be run at the proper speeds and 
feeds as they apply to the job.  Use only 
recommended accessories and follow those 
manufacturers instructions pertaining to them.  
Tooling shall be not be forced in to any 
workpiece but fed according to the proper 
specifications.  Failure to follow these 
instructions will not only ruin the tooling as well 
as the machine, but can cause serious injury.  

4.  Never brush away any chips while the machine 

is in operation.  All clean up should be done 
when the machine is stopped.   

5.  Keep hands in sight.  Do not put hands or 

fingers around, on, or below any rotating cutting 
tools.  Leather safety gloves should be used 
when handling any sharp objects or cutting 
tools.  See Figure A.   

6. Always wear protective eye wear when 

operating, servicing or adjusting machinery. 

 

Eyewear shall be impact resistant, protective 
safety glasses with side shields complying with 
ANSI Z87.1 specifications.  Use of the eye wear 
which does not comply with ANSI Z87.1 
specifications could result in severe injury from 
breakage of eye protection. See Figure B.   

7.  When drilling in material which causes dust, a 

dust mask shall be worn.  See Figure C.   

8.  Avoid contact with coolant, especially guarding 

the eyes.   

9. Non-slip footwear and safety shoes are 

recommended.  See Figure D.   

10. Wear ear protectors (plugs or muffs) during 

extended periods of operation.  See Figure E. 

 

            A                 B                  C                 D 
 

 

 

 

 

 

To avoid accidental starting by young children or 
others childrennot qualified to use the tool, the use 
of a padlock is required. 

1.  Open the padlock (Fig E). 

2.  Insert the through hole in the switch cover. 

3.  Close the padlock (Fig F). 

4.  Place the key in a safe place.