KitchenAid KUDS01FL 用户手册

NOTE: The dishwasher door can be opened while the controls 
are locked.

To turn on the Lock
Press and hold

for 4 seconds. Control Lock glows.

If you press any pad while your dishwasher control is locked, the 
light flashes 3 times.

To turn off the Lock
Press and hold ENERGY SAVER™ Dry control for 4 seconds. The 
light turns off.

Select this option to run your dishwasher at a later time or during 
off-peak hours. You can add items to the load anytime during the 
delay countdown. After adding items, close the door firmly until it 
latches. The delay countdown will not continue if the door is not 
latched.

1. Open the door.

2. Select a wash cycle and options.

3. Press

The delay light will glow.

4. Press Start. The selected cycle and option will flash once to 

tell you that the delay has started.

5. Close the door.

NOTE: To cancel the delay, press 4 Hour Delay to turn the light 
off.

■

Operate your dishwasher only when you are at home.

■

If your home is equipped with a water softener, do not start 
the dishwasher during the regeneration of the softener.

If you select the SANI RINSE™ option, Sanitized glows when the 
SANI RINSE™ cycle is finished. The light turns on when you open 
the door. If your dishwasher did not properly sanitize your dishes, 
the light flashes at the end of the cycle. This can happen if the 
cycle is interrupted or the incoming water temperature is too low. 
The light goes off when you close the door or press Cancel.

Clean glows when a cycle is finished. The light turns on when you 
open the door. The light turns off when you open and close the 
door or press Cancel.

The five-level wash system provides excellent cleaning results. 
Four levels of filtration and a soil collector system filter the wash 
water and prevent food particles from redepositing on the clean 
dishes.

■

The wash water continuously flows through the Ultra-Fine 
filter, trapping food particles. 

■

As the Ultra-Fine Filter traps food particles, the pressure in 
the pump increases. The sensor monitors this pressure and 
automatically adjusts the wash cycle for the best wash 
performance.

■

Two water jets, located under the spray arm, remove the food 
particles from the Ultra-Fine filter.

■

A coarse strainer prevents bones, pits, and other large 
objects from entering the pump system.

NOTE: Periodically check the coarse strainer and remove any 
objects on the strainer.

While the dishwasher is “sensing,” it may perform a series of 
short drains and fills skimming off small amounts of soils and 
dirty water. These are simultaneously replaced with clean water. 
This removes trapped food particles from the pump for improved 
wash performance. Once soil level is determined, the sensor 
automatically adds heat, time, or water as needed for proper 
cleaning.

The vent, located on the top left side of the door, serves several 
purposes.

During the cycle, it closes to lock sound in the dishwasher. After 
the cycle has finished, the vent remains closed until the dishes 
have cooled down. Between cycles, the vent stays open for 
airflow, reducing the buildup of odors. It also helps relieve air 
pressure, allowing you to close the dishwasher door more easily.

The overfill protection float (in the front right corner of the 
dishwasher tub) keeps the dishwasher from overfilling. It must be 
in place for the dishwasher to operate. 

Check under the float for objects that may keep the protector 
from moving up or down.