KitchenAid KUDC25CH 用户手册

下载
页码 52
12
NOTE: Fill amounts shown are for standard powdered 
detergent. Amounts may vary if you use liquid or 
concentrated powdered detergent. Follow instructions on 
the package when using liquid dishwasher detergent or 
concentrated powdered detergent.
Rinse Aid Dispenser
Rinse aids prevent water from forming droplets that can 
dry as spots or streaks. They also improve drying by 
allowing water to drain off of the dishes during the final 
rinse by releasing a small amount of the rinse aid into the 
rinse water. Your dishwasher is designed to use a liquid 
rinse aid. Do not use a solid or bar-type.
Filling the dispenser
The rinse aid dispenser holds 5.2 oz (153.7 mL) of rinse 
aid. Under normal conditions, this will last for about three 
months. You do not have to wait until the dispenser is 
empty to refill it. Try to keep it full, but be careful not to 
overfill it.
1. Make sure the dishwasher door is fully open.
2. Turn the dispenser knob to OPEN and lift it out.
3. Add rinse aid until the indicator window looks full.
4. Clean up any spilled rinse aid with a damp cloth.
5. Replace the dispenser knob and turn it to CLOSED.
Rinse aid setting
The amount of rinse aid released into the final wash can be 
adjusted. The factory setting is at 2. For most water 
conditions set the adjuster to 1 or 2. If there are rings or 
calcium (hard water) spots on dishes, try a higher setting.
To adjust the setting
Remove the dispenser knob, then turn the adjuster inside 
the dispenser to the desired setting.
Water Hardness
Amount of Detergent
Soft to Medium 
Hard Water 
0 to 6 grains per 
gallon
For normally soiled loads:
Partially fill the Main Wash 
section (2 tbs or 30 g)
Fill the Pre-Wash section 
(2 tbs or 30 g)
NOTE: Add only 1 tb or 15 g of 
detergent to the Pre-Wash 
section if dishes are pre-rinsed or 
the water is very soft (0 to 2 
grains per gallon).
For baked on soil loads:
Fill the Main Wash section 
(2 tbs or 30 g)
Fill the Pre-Wash section 
(2 tbs or 30 g)
For heavily soiled loads:
Fill the Main Wash section 
(3 tbs or 45 g)
Fill the Pre-Wash section 
(2 tbs or 30 g)
Medium to Hard 
Water
7 to 12 grains per 
gallon
For normal and heavily soiled 
loads:
Fill the Main Wash section 
(3 tbs or 45 g)
Fill the Pre-Wash section 
(2 tbs or 30 g)
Very Hard Water
13 grains per 
gallon and above
NOTE: It might be 
necessary to use 
the Soak & Scrub 
cycle, or the 
Normal cycle with 
either a High Temp 
wash (if available) 
or Super Scrub 
option (if available) 
for best wash 
performance with 
very hard water.
For normally soiled loads:
Fill the Main Wash section 
(3 tbs or 45 g)
Fill the Pre-Wash section 
(2 tbs or 30 g)
Turn the rinse aid dispenser to 
a higher setting. See “Rinse 
Aid Dispenser” later in this 
section.
For heavily soiled loads:
Fill the Main Wash section 
(3 tbs or 45 g)
Fill the Pre-Wash section 
(2 tbs or 30 g)
Turn the rinse aid dispenser to 
a higher setting. See “Rinse 
Aid Dispenser” later in this 
section.