KitchenAid KUDE03FTBL 用户指南

IMPORTANT: The sensor in your dishwasher monitors the soil level. Cycle time and/or water usage can vary as the sensor adjusts the 
cycle for the best wash performance. If the incoming water is less than the recommended temperature or food soils are heavy, the cycle 
will automatically compensate by adding time, heat and water as needed.

 

Pans, casseroles, etc. with 
tough food soil.

Activates the PROSCRUB

®

 spray jets and provides 

intensified water spray to the back of the lower level rack.
May add heat and time to the cycle.

Heavy Duty or Normal 
cycle

To sanitize your dishes and 
glassware in accordance 
with NSF/ANSI Standard 
184 for Residential 
Dishwashers.

Raises the water temperature in the final rinse to 
approximately 155°F (68°C). This high temperature rinse 
sanitizes your dishes and glassware in accordance with 
NSF/ANSI Standard 184 for Residential Dishwashers. 
Certified residential dishwashers are not intended for 
licensed food establishments.

The Sanitize or Sani Rinse option adds heat and time to the 
cycle.

Normal cycle. Heavy 
Duty cycle automatically 
uses Sani Rinse. Only 
these sanitization cycles 
have been designed to 
meet the NSF/ANSI 
requirements.

Loads containing tough, 
baked-on food.

Increases the target water temperature during the wash 
portions of the cycle.

Adds heat, wash time and water to the cycle.

Heavy Duty or Normal 
cycles

For best drying results, dry 
dishes with heat.

Turn OFF when loads contain plastic dinnerware that may be 
sensitive to high temperatures.

This option with the use of rinse aid will provide the best 
drying performance. 

All cycles, except Rinse 
Only. Automatic with all 
wash cycles unless you 
turn it off.

To run your dish washer at 
a later time or during off-
peak hours.

Delays the start of a cycle up to 4 hours.

Select a wash cycle and options. Press 4 Hour Delay. Press 
START/RESUME. Close the door firmly. 

All cycles, except Rinse 
Only

To avoid unintended use of 
your dishwasher, or cycle 
and option changes during 
a cycle.

To turn on Lock, press and hold Heat Dry for at least 
4 seconds. 

To turn off Lock, press and hold Heat Dry for at least 
4 seconds. 

When Control Lock is lit, all buttons are disabled. If you press 
any pad while your dishwasher is locked, the light flashes 
3 times. The dishwasher door can be opened while the 
controls are locked. 

Anytime

To start or resume a 
wash cycle

If the door is opened during a cycle or the power is interrupted, the Start/Resume indicator 
flashes. The cycle will not resume until the door is closed and Start/Resume is pressed.

To cancel wash 
cycle 

Close the door firmly. The dishwasher starts a 2-minute drain (if needed). Let the dishwasher 
drain completely.

To follow the 
progress of your 
dishwasher cycle

Clean indicator glows when a cycle is finished. 

If you select the Sani Rinse option, when the Sani Rinse cycle is finished, the Sanitized indicator 
glows. If your dishwasher did not properly sanitize your dishes, the light flashes at the end of the 
cycle. This can happen if the cycle is interrupted, or the water could not be heated to the required 
temperature. The light goes off when you open and close the door or press CANCEL.