Smeg PGF95-1 用户手册

 

 

Create an opening with the dimensions 
shown in the figure in the work surface, 
observing a minimum distance of  50 mm 
from the rear edge. 
The lower part of the protective cover 
must be fully accessible when the 
appliance is installed. This appliance can 
be installed next to walls that are higher 
than the work surface, as long as the 
distance "X" is kept, as shown in the 
figure, to avoid damage from overheating. 

1) 

Make sure there is a minimum of 750 mm (Fig. 1) between the gas rings and any shelf 
that may be installed directly above them. 
This type of appliance requires the 
worktop, the dimensions of which are 
shown shown in figure 2, to be milled to a 
depth of 2.5 mm. Before positioning the 
hob, position the adhesive sponge 
material “E” supplied over the milled 
surface (fig. 3). Having done this, place 
the hob on the milled surface and using 
the screws and fixing brackets “C” or “D” 
(depending on  the depth of the worktop) 
secure the hob to the support structure, 

2) 

ensuring it is level. The brackets “C” 
secure the hob to a structure having a 
depth of 20 to 30 mm. The brackets “D” 
on the other hand, are for use with 
worktops having a depth of 30 to 50 mm. 

3) 

 

 

 

24