Smeg AP2640TC1 用户手册

 

Instructions for the user 

 

26 

Some models are equipped with a 1 to 99-minute cooking timer.  
To use the timed cooking, first set the power level by following the instructions given in paragraphs  
“7.2.2 Single Cooking Zones” and “7.2.3 Dual Cooking Zones”. 
Now, with the hob NOT locked out (if it is locked out, press the 

 key to enable the functions), press 

the symbol 

. 

Between the symbols 

 and 

 of the first active cooking zone, a LED light will turn on to indicate that 

the minutes to be set will refer to operation of that particular zone.  
The automatic operation minutes of the cooking zone can be increased or decreased by using the 

 

and 

 keys beside 

 . 

After 5 seconds have gone by since the last time it is pressed, the timer will start and the cooking zone 
will operate until the display above the symbol 

 reaches 0. 

At this point the cooking zone will automatically turn off.   
It is also possible to use the timed cooking function on more than cooking zone at the same time. 
Once the timer is set on the first zone, press 

 key to shift the timer controls over to the next active 

zone (the LED light between the symbols 

 and 

 of the second active cooking zone will be 

activated) and then set the cooking duration as previously described.  
When the timed cooking is active on several cooking zones at the same time, the display between the 
symbols 

 and 

 of the cooking zone will alternatively turn on and at the same time the minutes 

display found on the symbol 

 will show the time remaining for the zone with the LED light on. 

 

 

During timed cooking, each single pressure on the 

 and 

 symbols increases or reduces the power 

of the cooking zone. 
To change the remaining time of a zone, you have to press 

 key until the LED light in the cooking 

zone turns on. Now it will be possible to change the operating time by working with the symbols 

 

and 

 of the timer. 

 

 

Each cooking zone is equipped with a residual heat warning device. After any zone is switched off, a 
flashing “

”may appear on the display. This warns that the cooking zone concerned is still very hot. 

Cooking can be restarted while the 

 is flashing; proceed as described in points “7.2.2 / 7.2.3”.

 

 

 

If the cooking zones cause overheating of the internal electronic circuit board, the heat will be switched 
off automatically. This switches off power to the front zones, and the letters 

 and 

 flash alternately 

on the power leds. If the circuit board does not cool down, power to all the cooking zones is switched 
off, and the power leds display the text 

 

 

 

. Cooking can be resumed once the temperature 

has dropped below the safety threshold. 

 

 

If the user makes a mistake when using the push-buttons, an 

 appears on the power display; it will 

remain there as long as the user continues to press the button being used incorrectly. 

 

 

The cooking zones are switched off when the operational power display indicates 0. The zone will 
automatically deactivate 5 seconds after the display shows 0.  
If the cooking zones are hot, the blinking residual heat “

” will appear after they are switched off.