Haier HVH014A 用户手册

1. Remove all packaging material. This includes the foam base and all

adhesive tape holding the wine cooler accessories inside and outside.

2. Inspect and remove any remains of packing, tape or printed

materials before powering on the wine cooler.

• Your wine cooler has two leveling legs which are located in the

front of your wine cooler. After properly placing your wine cooler in its
final position, you can level your wine cooler.

• Leveling legs can be adjusted by turning them clockwise to raise your

wine cooler or by turning them counterclockwise to lower
your wine cooler. The wine cooler door will close easier when the
leveling legs are extended. 

• Also, there is an adjustable support for the lower door hinge. (see fig.5)

After leveling the Beverage Center, adjust the hinge support, up or down
as needed until it rests on the surface on which that unit is placed.

• To assure your wine cooler works at the maximum efficiency it 

was designed for, you should install it in a location where there 
is proper air circulation, plumbing and electrical connections.

• The following are recommended clearances around the wine cooler:

Sides……………2 "(50mm)
Top....................2" (50mm)
Back..................2" (50mm)

• Do not over fill your wine cooler for proper internal air circulation.