Russell Hobbs RHDW1 用户手册
Water connection
Be sure that the indoor plumbing is suitable for installing a dishwasher. Also, we recommend that you
fit a filter
Be sure that the indoor plumbing is suitable for installing a dishwasher. Also, we recommend that you
fit a filter
to the water pipe or tap so as to avoid any damage to your machine
because of any contamination (sand, clay, rust etc.) that might be occasionally carried in through the
mains water supply or the indoor plumbing, and to forestall such complaints as yellowing and
formation of deposits after washing.
mains water supply or the indoor plumbing, and to forestall such complaints as yellowing and
formation of deposits after washing.
Water inlet hose
Do not use the water inlet hose of your old machine,
Do not use the water inlet hose of your old machine,
or of any other machine
Use the new water inlet hose supplied with your machine instead. If you are
going to connect a new or long-unused water inlet hose to your machine, run
water through it for a while before making the connection. Connect the water
inlet hose directly to the water inlet tap. The pressure supplied by the tap
should be at a minimum of 0.03 Mpa and and at a maximum of 1 Mpa. If the
water pressure is above 1 Mpa, a pressure-relief valve should be fitted
inbetween. After the connections are made, the tap should be turned on fully
and checked for water tightness.
For the safety of your machine, make sure to always turn off the water inlet
tap after each wash programme is finished.
going to connect a new or long-unused water inlet hose to your machine, run
water through it for a while before making the connection. Connect the water
inlet hose directly to the water inlet tap. The pressure supplied by the tap
should be at a minimum of 0.03 Mpa and and at a maximum of 1 Mpa. If the
water pressure is above 1 Mpa, a pressure-relief valve should be fitted
inbetween. After the connections are made, the tap should be turned on fully
and checked for water tightness.
For the safety of your machine, make sure to always turn off the water inlet
tap after each wash programme is finished.
NOTE: Aquastop water spout is used in some models. In case of
using Aquastop, a dangerous tension exists. Do not cut
Aquastop water spout. Do not let it get folded or twisted.
Water outlet hose
The water drain hose can be connected either directly to the water
drain hole or to the sink outlet spigot. Using a special bent pipe (if
available), the water can be drained directly into the sink via hooking
the bent pipe over the edge of the sink.
This connection should be at a minimum of 50 cm and and at a
maximum of 110 cm from the floor plane.
Warning: When a drain hose longer than 4 m is used, the dishes
might remain dirty. In that case, our company will not accept
responsibility.
The water drain hose can be connected either directly to the water
drain hole or to the sink outlet spigot. Using a special bent pipe (if
available), the water can be drained directly into the sink via hooking
the bent pipe over the edge of the sink.
This connection should be at a minimum of 50 cm and and at a
maximum of 110 cm from the floor plane.
Warning: When a drain hose longer than 4 m is used, the dishes
might remain dirty. In that case, our company will not accept
responsibility.
8