Stanley Black & Decker GT18B02 用户手册

Do not operate the power unit until you have read the 

engine operating and maintenance instructions manual 

furnished with the unit.

1. ENGINE CRANKCASE OIL LEVEL  

   

Always check the oil level before starting the engine. Make 

sure the oil level is at the FULL MARK on the dipstick. Do 

not overfill. Use detergent oil classified "For Service SE, 

SF, SG" as specified in the engine operating and mainte-

nance manual. See engine manual for oil viscosity grade.

On power units equipped with Briggs & Stratton Engines, 

ONLY Champion RC12YC or equivalent can be used.

Incorrect type spark plugs can produce radio frequency 

interference that will corrupt and damage the controller. 

Failure to use the correct spark plug could result in a war-

ranty that will not be considered.

 

Check the fuel level. If low, fill with un-leaded gasoline with 

a minimum of 85 octane. 

          

            

Check the dip stick in the hydraulic fluid reservoir for the 

proper fiuid level. Use fluids meeting the following specifi-

cations.

Viscosity (Fluid Thickness)

U.S. 

   METRIC

50°F 450 SSU Maximum 

10°C 95 C.S.

100°F 130-200 SSU 

 

38°C 27-42 C.S.

140°F 85 SSU Minimum  

60°C 16.5 C.S. Min

Pour Point -10°F/-23°C Minimum (for cold startup)

Viscosity Index  (ASTM D-2220) 140 Minimum

Demulsibility  (ASTM D-1401) 30 Minutes Maximum

Flash Point  (ASTM D-92) 340°F/171°C Minimum

Rust Inhibition  (ASTM D-665 A & B) Pass

Oxidation  (ASTM D-943) 1000 Hours Minimum

Pump Wear Test  (ASTM D-2882) 60 mg Maximum 

The following fluids work well over a wide temperature 

range, allow moisture to settle out and resist biological 

growth that may occur in cool operating hydraulic circuits.  

These fluids are recommended by Stanley.  Other fluids 

that meet or exceed the specifications of these fluids may 

also be used.

Chevron AW-MV-32

Exxon "Univis" J-26

Mobil D.T.E. 13

Gulf "Harmony" AW-HVI-150-32

Shell "Tellus" T-32

Texaco "Rando" HD-AZ

Union "Unax" AW-WR-32

Terresolve EnviroLogic 132

The recommended hose length is 25 ft/8 m with a 1/2 

inch/12.7 mm inside diameter.  The hoses must have a 

working pressure rating of at least 2500 psi/175 bar.  Each 

hose end must have male thread ends compatible with 

H.T.M.A. (HYDRAULIC TOOL MANUFACTURERS AS-

SOCIATION) quick disconnect fittings (NPT type threads).  

(See Figure 2.)

Figure 1. Control Panel

Facing the control panel, the bottom male quick disconnect 

fitting is the PRESSURE FLUID OUT fitting. The top female 

quick disconnect fitting is the RETURN FLUID IN fitting.