Stanley Black & Decker GT18B02 用户手册

1.  Use the procedures described under "STARTUP" and 

then follow the procedure below.

2.  Hydraulic fluids are thicker in cold weather. Therefore, 

it is recommended that the engine be run at low idle long 

enough to bring the fluid temperature up to a minimum of 

50°F/10°C. 

3.  If the tools and tool hoses are cold, it is recommended 

to allow hydraulic fluid to circulate through the tool hoses 

until warm before using the tool.

1.  Ensure the flow selector switch in the OFF position 

(center position).

 2.  Unless already at idle the power unit should return to 

idle. This may take a few seconds for the unit to react due 

to a built-in program delay.

3.  Allow the engine to idle for approximately one minute 

and move the Ignition Switch to the OFF position.