Liebherr 7083 461-00 用户手册

2

•  Avoid positioning the appliance in direct sunlight or near cookers, 

radiators and similar sources of heat.

•  The floor on which the appliance stands should be horizontal 

and level. 

•  The ventilation grilles should not be obstructed. Always ensure 

that there is good ventilation and that the outward flowing air is 

able to escape.

•  Standard EN 378 specifies that the room in which you install 

your appliance must have a volume of 1 m³ per 8 g of R 600a 

refrigerant used in the appliance, so as to avoid the formation of 

inflammable gas/air mixtures in the room where the appliance 

is located in the event of a leak in the refrigerant circuit. The 

quantity of refrigerant used in your appliance is indicated on the 

type plate on the inside of the appliance.

The required air flow is directed 

through the plinth. 

It is important to use the provided 

ventilation grille for the ventilation 

opening. 

This opening must not be cov-

ered.

Failure to use the supplied grille 

can result in product failure and 

will void the warranty.

Only operate the appliance with alternating current (AC).

The permissible voltage and frequency are indicated on the type 

plate. The position of the type plate is shown in the description of 

the appliance.

The socket must be properly earthed and protected by a fuse.

The tripping current of the fuse must be between 10 A and 16 A.

The socket must not be situated behind the appliance and must 

be easily accessible.

Do not connect the appliance using an exten-

sion cable or extension socket.
Do not use stand-alone inverters (conversion 

of direct current to alternating/three-phase cur-

rent) or energy-saving plugs. Risk of damage 

to the electronic control system!

Please allow for door swing clearance 

at locations next to a wall. 
The illustrated measurement is with-

out mounted front panels. 

Be sure to add your panel thickness 

and  handle  depth  to  this  measure-

ment in order to avoid interferences.

Setting up ...................................................................................2

Electrical connection ..................................................................2

Appliance venting .......................................................................2

Door swing clearance .................................................................2

Appliance dimensions ................................................................3

Installation dimensions ...............................................................3

Mounting the anti-tipping device ................................................4

Mounting options ........................................................................4

Connection to the water supply ..................................................5

Leveling the appliance ...............................................................7

Fastening the appliance in the recess ........................................7

Adjusting the refrigerator door ....................................................7

Adjusting the front of the drawer .................................................7

Mounting the ventilation grille .....................................................8

Before fitting the door panels .....................................................9

Panel dimensions .......................................................................9

Mounting the attachment brackets onto the door panels .........10

Mounting the refrigerator panel ................................................11

Mounting the freezer panels .....................................................13

Changing over door hinges ......................................................13