Watlow Electric 988 用户手册

WATLOW Series 988 User’s Manual

Factory Menus, Chapter 6

To reach the Factory Menus, begin in the Display Loop and press the Up-
arrow > and Down-arrow < keys together and hold for three seconds.
The [`SEt] prompt will appear in the lower display. Press and hold the
Up-arrow > and Down-arrow < keys together again for three seconds
until the [Fcty] prompt appears in the lower display. The Factory Menus
will not appear if the hardware lockout DIP is set to on. (See 

for

more information on DIP switch settings.) The three Factory Menus are:
Panel Lockout [PLOC]; Diagnostics [diAg]; and Calibration [`CAL]. Upon
reaching the Factory Menu prompt [Fcty] use the Up-arrow > or Down-
arrow < key to select a menu and the Mode key µ to step through a
menu.

You will not see every prompt in any of these menus. The unit’s configura-
tion and model number determine which prompts appear. After stepping
through each menu, the Series 988 returns to the Factory Menu prompt
[Fcty]. Use the Up-arrow > and Down-arrow < keys to select the next
menu, or use the Mode key µ to advance through the same menu again.
To move backwards through the menu hold down the Mode key µ and
press the Up-arrow key >. Use the Up-arrow > or Down-arrow <
key to change the prompt setting.

Chapter 6 The Factory Menus

[PLOC]

[diAg]  [`CAL]

[Fcty]

[Fcty]

[Fcty]

❶ Press the Up-arrow > and Down-arrow < keys
together and hold until the [`SEt] prompt appears in
the lower display. Press and hold again until the
[Fcty] prompt appears in the lower display.

❷ Use the Up-arrow key > to select one of the
Factory Menus.

˜

∂

˜

[`SEt]

Panel

Diagnostics Calibration

Lockout

Menu

Menu

Menu

˜