Standard Horizon GX3000S 用户手册
GX3000S
Page 80
14.4 MANUAL INPUTTING OF THE GPS LOCATION (LAT/LON)
You may send the Latitude/Longitude of your vessel manually from the VH-310
Handset even if the GX3000S is not connected the GPS receiver unit.
Handset even if the GX3000S is not connected the GPS receiver unit.
After the position is entered, transmitting a DSC Distress, Position Request, or
Position Send will contain the manually entered position.
Position Send will contain the manually entered position.
1. Press and hold down the [CALL(MENU)] key until “
Radio
Setup
” menu appears.
2. Press the [
] key to select “
DSC SETUP
” menu.
3. Press the [ENT] key, then select “
POS INPUT
” with the [
]/
[
] key.
4. Press the [ENT] key then, enter the your local time from the
keypad by the 24-hour system on the UTC time.
5. Enter the Latitude of your vessel location (xx.xx.xx) by the
keypad, then press the [6(NAV)] key to select North (N), or
[7(SCRM)] key to select South (S).
[7(SCRM)] key to select South (S).
6. Enter the Longitude of your vessel location (xxx.xx.xx) by
the keypad, then press the [3(SCAN)] to select East (E), or
[9(FOG)] key to select West (W).
[9(FOG)] key to select West (W).
7. If a number was entered by mistake, press the H/L key re-
peatedly to select the number. Press the [
]/[] key to se-
lect the desired number.
8. Press and hold in the [ENT] key to store the data entered,
then press the [16/9] key to exit this menu and return to
radio operation mode.
radio operation mode.