3M MDS100 用户手册
5
EN
(English)
WARNING
•
To reduce the risks associated with hazardous voltage and fire:
- keep power supply visible and accessible at all times. Use the plug at the wall socket to disconnect the device
from the main power supply.
- use only the power cord specified for this product and certified for the country of use.
- do not allow the power supply to get wet.
- do not modify, or service this instrument. Use only 3M authorized service personnel.
- do not use the power supply if the enclosure is broken.
- do not use this instrument if power cord is damaged. Use only 3M authorized service personnel. Use only 3M
- do not allow the power supply to get wet.
- do not modify, or service this instrument. Use only 3M authorized service personnel.
- do not use the power supply if the enclosure is broken.
- do not use this instrument if power cord is damaged. Use only 3M authorized service personnel. Use only 3M
specified replacement parts.
•
To reduce the risks associated with exposure to chemicals and biohazards:
- always follow standard lab safety practices, including wearing appropriate protective apparel and eye
protection while using this instrument.
- always perform the decontamination procedure prior to returning the instrument for service and prior to
disposal.
•
To reduce the risks associated with false-negative results leading to the release of contaminated product:
- install instrument on a solid, dry, level surface, allowing approximately 30cm of clearance above the unit for
opening the door.
- do not use the instrument when it appears the instrument or any component is damaged.
•
To reduce the risks associated with amplicon contamination and false-positive results:
- do not open reagent tubes after a run is completed.
- decontaminate the 3M Molecular Detection Instrument regularly with a 1-5% (v:v in water) household bleach
- decontaminate the 3M Molecular Detection Instrument regularly with a 1-5% (v:v in water) household bleach
solution (refer to Cleaning section).
CAUTION
•
To reduce the risks associated with exposure to chemicals:
- read, understand and follow the safety information on the isopropanol and bleach containers and their
associated MSDS’.
•
To reduce the risks associated with environmental contamination:
- follow applicable regulations when disposing of this device or any of its electronic components.
•
To reduce the risks associated with hot surfaces:
- avoid direct contact with the aluminum heating block insert when hot.
NOTICE
•
To avoid instrument damage:
- do not use solvents such as acetone or thinner to clean the instrument; avoid abrasive cleaners.
- clean instrument exterior with soft cloth using plain water or a mild, all-purpose or nonabrasive cleaner.
- Only use the recommended cleaning and disinfection agents specified in these instructions. Contact the
- clean instrument exterior with soft cloth using plain water or a mild, all-purpose or nonabrasive cleaner.
- Only use the recommended cleaning and disinfection agents specified in these instructions. Contact the
manufacturer if there is any doubt about the compatibility of these agents with any part of the equipment.
- If the equipment is used in a manner not specified in this manual, the protection provided by the equipment
may be impaired.