Smeg S709X-7 用户手册

 

 

52 

8.2.1  With type 1 mobile levers 
With the door completely open, lift the levers A of the two hinges until 
they touch the hinges B and take hold of the two sides of the door with 
both hands close to the hinges themselves. Raise the door to an angle of 
about 45° and remove it. If the hinges have not locked, repeat the 
operation, raising the levers and keeping the door slightly raised. To 
reassemble, fit the hinges B into their grooves, then lower the door into 
place, ensuring that it remains fitted into the grooves C, and lower the 
levers A. 

 

Open the door completely and insert the pins (supplied) into the holes 
from the inside. Close the door to an angle of about 45° and lift it off. To 
reassemble, fit the hinges into their grooves, then lower the door into 
place and extract the pins. If you should lose the pins, two screwdrivers 
can also be used. 

 

 

To permit thorough cleaning of the oven, the seal 
may be removed. Before removing the seal, take off 
the door as described above. Once the door has 
been taken off, lift the tabs at the corners as shown 
in the figure. 
After cleaning, refit the seal with the longer side 
horizontal and insert the tabs into the appropriate 
holes starting from the top ones.