Ryobi Outdoor 3000 PSI 用户手册

9

This product requires assembly.


  Carefully cut the box down the sides then remove the 

tool and any accessories from the box. Make sure that 
all items listed in the packing list are included.

 

NOTE: This tool is heavy. To avoid back injury, lift with 
your legs, not your back, and get help when needed.



  Remove and discard the clear cap securing the operator’s 

manual bag to the pump breather tube.



  Inspect the tool carefully to make sure no breakage or 

damage occurred during shipping.



  Do not discard the packing material until you have care-

fully inspected and satisfactorily operated the tool.



  If  any  parts  are  damaged  or  missing,  please  call 

1-800-860-4050 for assistance.

Pressure Washer
30 ft. High Pressure Hose
Spray Wand Assembly (upper)
Assist Handle Assembly
Spray Wand Extension (lower)
Quick-Connect Nozzle (5)
Nozzle Cleaning Tool
Resting Foot
Axle Assembly ()
Wheel ()
Washer ()
Hardware Bag
4-Cycle Engine Oil (10W-30)
Operator’s Manual

If any parts are damaged or missing do not operate this 
tool until the missing parts are replaced. Failure to heed 
this  warning  could  result  in  possible  serious  personal 
injury.

Fig. 

Do  not  attempt  to  modify  this  tool  or  create  accesso-
ries not recommended for use with this tool. Any such 
alteration or modification is misuse and could result in a 
hazardous condition leading to possible serious personal 
injury.

To prevent accidental starting that could cause serious 
personal injury, always disconnect the engine spark plug 
wire from the spark plug when assembling parts.

NOTE: Do not start the pressure washer until the engine has 
been filled with oil and all hoses are connected. Running this 
machine without oil will damage the engine while running it 
without water will damage the high pressure pump.

See Figure 2.
To 

attach the wheels to the pressure washer base:



  Locate the axle assembly; remove the hitch pin from the 

axle.



 

Slip the axle into the wheel hole and 

slide the washer onto 

the axle

.



  Lift  the  machine  and  slide  the  axle/wheel/washer 

combination into the wheel mounting hole in the machine 
base as shown.



  Push the hitch pin into the hole on the end of the axle to 

secure the wheel assembly.

 

NOTE: The hitch pin should be pushed into the axle until 
the center of the pin rests on top of the axle.



  Repeat with the second wheel assembly.

NOTE:  It  is  important  to  always  maintain  proper  air 
pressure in both wheels.