Whirlpool WGD9050X 用户手册

■

Is the exhaust vent or outside exhaust hood clogged with 
lint, restricting air movement? 

 

Run the dryer for 5-10 minutes. Hold your hand under the 
outside exhaust hood to check air movement. If you do not 
feel air movement, clean exhaust system of lint or replace 
exhaust vent with heavy metal or flexible metal vent. See the 
Installation Instructions.

■

Are fabric softener sheets blocking the grille? 

 

Use only one fabric softener sheet, and use it only once.

■

Is the exhaust vent the correct length? 

 

Check that the exhaust vent is not too long or has too many 
turns. Long venting will increase drying times. See the 
Installation Instructions. 

■

Is the exhaust vent diameter the correct size? 

 

Use 4" (102 mm) diameter vent material.

■

Is the dryer located in a room with temperature below 45ºF 
(7ºC)? 

 

Proper operation of dryer cycles requires temperatures above 
45ºF (7ºC).

■

Is the dryer located in a closet? 

 

Closet doors must have ventilation openings at the top and 
bottom of the door. The front of the dryer requires a minimum 
of 1" (25 mm) of airspace, and, for most installations, the rear 
of the dryer requires 5" (127 mm). See the Installation 
Instructions.

■

 

The load may not be contacting the moisture sensor strips. 
Level the dryer.

■

 

Clean lint screen. Check for air movement.

■

 

Add dryer fabric softener sheets at the beginning of the cycle. 
Fabric softener sheets added to a partially dried load can 

 

stain your garments. 

Drum stains are caused by dyes in clothing (usually blue 
jeans). These will not transfer to other clothing. 

■

 

Remove garments promptly to prevent wrinkling.

■

 

Dry smaller loads that can tumble freely. 

■

 

If so, ventilate the area. When the odors or fumes are gone 
from the area, rewash and dry the clothing. 

IMPORTANT: Your dryness level settings can be adjusted to 
adapt to different installations, environmental conditions, or 
personal preference. This change is retained and will affect all of 
your AUTOMATIC cycles, not just the current cycle/load. 
If all your loads on all AUTOMATIC Cycles are consistently not as 
dry as you would like, you may change the default settings to 
increase the default dryness level. This change will affect all of 
your Automatic Cycles.
There are 3 drying settings, which are displayed using the WET, 
DAMP, and COOL DOWN indicators: 

1. (factory preset dryness level) - WET indicator lit.
2. (slightly drier clothes, 15% more drying time) - WET and 

DAMP indicators lit. 

3. (much drier clothes, 30% more drying time) - WET, DAMP, 

and COOL DOWN indicators lit.

NOTE: The AUTOMATIC default settings cannot be changed 
while the dryer is running.
1. Press and hold the TEMP button for at least 6 seconds. The 

dryer will beep, and the current drying mode will be displayed.

2. To select a new drying setting, press the TEMP button again 

until the desired drying setting is shown. 

 

NOTE: While cycling through the settings, the current setting 
will be lit solid, but the other settings will flash.

3. Press the START/PAUSE button to save the drying setting and 

exit to standby mode.

 

NOTE: To exit without saving, press the POWER button.

4. The drying setting you selected will become your new preset 

drying setting for all AUTOMATIC cycles.