Toshiba A8-EZ8511 参考指南
30
Adding memory (optional)
5.375 x 8.375 ver 3.1
The following screen appears when you turn on the power:
If “Start Windows
®
Normally” is highlighted, then press
Enter
.
If one of the Safe Mode options is highlighted, it is best to press
Enter
to go into Safe Mode, then shut down and restart the system,
at which time Windows
®
should boot back up normally.
When Safe Mode is suggested, this could be a sign that you may
need to scan your hard drive for errors or defragment the drive. If
so, consult Windows
need to scan your hard drive for errors or defragment the drive. If
so, consult Windows
®
Help and Support.
2
Pull the latches away from the memory module.
The memory module pops up slightly.
If your system has the memory modules stacked on top of one
another, you must remove the top module first before removing/
installing the bottom module.
another, you must remove the top module first before removing/
installing the bottom module.
3
Gently lift the memory module to a 30-degree angle and slide it
out of the slot.
out of the slot.
4
Replace the memory module slot cover and tighten the screw.
5
Re-insert the main battery. For information on inserting the
main battery, see “Inserting a charged battery” on page 41.
main battery, see “Inserting a charged battery” on page 41.
6
Turn the computer right side up.
7
Reconnect the cables.
8
Restart the computer.
TECHNICAL NOTE: You must have at least one memory module
installed for the computer to work.
installed for the computer to work.
GMA500387010.book Page 30 Thursday, December 28, 2006 12:48 PM