Toshiba tdp-sp1u 用户指南

34

■

This menu shows placement status and other settings.

Item     

Description

Sets projection mode in accordance with Placement Style. 

(Standard) 

 

 

(Rear) 

 

  

(Ceiling) 

   

 (Rear ceiling)

Sets whether the input source with signals is only selected or not.

On     Off

Select one of the languages below to use for displaying the menu 
and messages
[   : Enter setting mode]   [         :Selection]   [Apply:   ]
English/Français/Deutsch/Italiano/Español/Português/

/Polski/ 

Bahasa Indonesia/Norsk/Suomi/Čeština/Magyar/Ελληνικά/Dansk/

Sets whether the start-up screen displays when power is turned on.

On     Off

Sets the cooling fan speed.

Sets the lamp power.

Sets whether to turn on the power when the 

ON/STANDBY button is 

pressed (Manual), or when the power cord is plugged in (Auto).

Automatically searches the input source that can be projected, and switches source 

from the connected device each time the 

INPUT button is pressed. If the connected 

device outputs no source signal, the input is skipped. When the source signal is 

stopped during projecting, it will switch to the other inputs automatically. If no input 

sources are detected, it will stop searching and 

“No signal” message will appear. 

Setting [

Fan mode] to [High] increases the cooling fan speed. (The cooling fan 

noise gets louder.) Set this option to use the projector, for example, at high altitude 

(over 1,500m or 5000 ft. above sea level).

  [Lamp power]

When [

Lamp power] is set to [Low], the screen becomes a little darker, but the 

cooling fan noise gets quieter.

If 

[Power on] is set to [Auto] and there is a power outage, the projector will come 

on once power is restored.